Building Our Water Treatment System

Adam, having worked under the careful guidance of Edwin Tomas (Silicon Valley Mechanical), cut the copper fittings and built the components.  Then, he sweated the components together into separate assemblies.

Adam started by making a jig that would hold the components …

 

Then started ‘sweating’ the pieces together to create the components …

 

And, finally, sweated the components together and made the assembly.

 

The two assembies were joined and the complete system pressure tested to 100 PSI overnight. The system is in front of where it will be cut into the actual water supply. Note that we moved the potassium tank into the corner.

Leave a Reply

Your email address will not be published. Required fields are marked *